1033297A - 4/18
WATER* and
UPRIGHT BIKES**
LONG
CARRIAGE BOLT
SPACER
WASHER AND NUT
*KAYAK STACKERS (single-post style) will not
work with this product.
**ANKLEBITERS will not work with this product.
**COBRA CARRIERS SEE BELOW.
Cobra and
KingCobra
ADAPTER
USE COBRA
CARRIAGE BOLT
(accessory here)
REMOVE THE UPPER PAD BEFORE CONTINUING.
1. Insert the long carriage bolt through the accessory and
into the spacer (your accessory may look different).
2. Secure the spacer and accessory to the backbone using
the washer and nut. Tighten with wrench.
3. Reattach the pad.
4. Attach to crossbar, secure with bail and wheel.
5. Read warnings on final page!
(Cobra plate)
REMOVE THE UPPER PAD BEFORE
CONTINUING.
1. Insert the carriage bolt from your Cobra
carrier, through the adapter and the
Cobra plate.
2. Secure the adapter and Cobra plate to
the backbone using the Cobra knob.
3. Reattach the pad.
4. Attach to crossbar, secure with bail and
wheel.
5. Read warnings on final page!
COBRA WHEEL TRAY:
Use the long carriage
bolt from this kit.
BIKE WHEEL TRAY:
Use the short carriage
bolt from this kit.
CARGO: continued next page
➤
ADAPTER POSITION:
If your factory bars are angled, and the
adapter is not flat against the accessory,
loosen the carriage bolt and rotate the
adapter on the MightyMount.
You will need to remove the pad; be sure
to replace it once the bolt is tightened.
WRENCH
SPACER POSITION:
If your factory bars are angled, and the spacer is not
flat against the accessory, loosen the carriage bolt
and rotate the spacer on the MightyMount.
You will need to remove the pad; be sure to replace
it once the bolt is tightened.
WRENCH
WRENCH
(Cobra knob)
