Instruction #1035941C-2/9
INSTALL THE CLAMPS.
LIFT THE BOX ONTO THE VEHICLE AND OPEN IT.
fit label
étiquette
etiqueta del
producto
A
2
1
B
2X
C
4X
2 Nm
A.
Place the plates along the center
slot of the box directly above your
crossbars. Make sure one plate is
mounted on both sides of the fit
label as shown.
B.
Place the clamp around the
crossbar and thread it through
the slot and the holes in the plate.
Reposition the plates as needed
and try to center the two plates in
order to distribute the load evenly.
C.
Screw the knobs onto the clamp.
Tighten to 2 Nm.
A.
With help from a friend lift the
box onto your vehicle and center
it on the crossbars. If mounting
it near the edge, the box must be
fully supported by the crossbar.
B.
The keys are taped to the
side of the box. Use one to
unlock the box by turning it
counterclockwise in the lock,
then lift up on the lid to open the
box.
C.
Remove hardware bag.
INSTALLATION • INSTALLATION • INSTALACIÓN
2X
Note:
If
mounting near
the edge, the
box must be
fully supported
by the crossbars.
Make sure the
instalation is secure
by tugging at the box.
• The box should not slide
on the bars.
• Open the box and tighten
knobs if necessary.
CENTER THE BOX ON
THE CROSSBARS.
