1033431B - 4/15
M4
ATTAch The ReAR cOveRs.
• secure with screws.
• tighten with Q-tower wrench or 4 mm hex wrench.
- the stretch kit has a left and a Right tube.
- the tubes slide to adjust.
- the housing holds the rear clip assembly.
POsITION ReAR RAck.
• use m4 measurement (from clip sheet).
• measure from centers of crossbar ends.
Be sure the towers are an
equal distance from the edge
of the roof on each side.
tuBe hook
housing
tuBes
sleeves
sleeve hook
slide Both housings to the
ReAR of the CAR until they stoP
(unless a measurement is noted in
your Clip instructions).
PRePARe TO INsTAll
The sTReTch kIT.
(front of car)
The fRONT TOWeRs AND bAR
shOulD AlReADy be INsTAlleD.
• open car doors.
• set rear rack on the roof.
HOOK IN AND DOWN.
Attach a clip holder assembly to one
of the housings.
• engage the adjustment post with six-half turns.
• Repeat for other side, six half-turns only.
slide each hook into the rectangular
opening on the back of the towers.
(stop
buttons)
