1033431B - /15
M
3
M
3
M
3
ON A NeW INsTAllATION, DIsAsseMble The TWO ReAR TOWeRs.
• open the cam cover.
• Completely unscrew the adjustment post.
• Carefully lift out the clip holder assembly, and set aside.
CAm
CoveR
Adjustment
Post
CliP
holdeR
AssemBly
AsseMble ReAR clIPs.
• insert fastener and push it down
over lock housing.
• do not instAll loCks yet.
insert lock housing through
clip, matching the notches.
If Q-Towers
are already
InsTalled
GO TO sTeP 6.
fIrsT TIme
Q-Tower InsTallaTIon:
install the front towers
(Q-tower instructions)
and continue below.
On a flat surface…
find the measurement for your car
wITh a Q-sTreTch KIT.
• find your car’s m3 in the clip sheet.
• Position towers at the new m3 distance,
measuring from inboard tower edges.
1. Completely tighten first tower screw
.
2. Apply firm downward pressure to
crossbar and tighten second tower.
When using the
wrench, insert the
short end, hold the
long seCtion.
After tightening
both towers,
measure again to
be sure the towers
have not moved.
conTInUe To sTeP 10
insert the correct clip
into the rear clip holders.
then snap towers closed.
“snAP”
