28-13-016-Rev1
8/10
INSERT LEGS
Slide Leg assemblies into the underside channel of
LOCKN’LOAD Bars. Slide in until Leg reaches Slot Cover.
Do not compress slot cover.
Connect all End Cap Halves together.
END CAP ASSEMBLY
From the LOCKN’LOAD Leg
Kit, insert Bottle Openers and
Pins into the End Cap Halves.
SECURE LEGS TO BARS
Tighten all M8 Set Screws
to 7Nm using a 13mm
Socket Wrench.
BAR SLOT COVERS (OUTSIDE LEG)
Measure the Bar channel outside of the Legs and
subtract 20mm from this measurement. Using the
remaining pieces of Slot Cover from Step 22, cut to
this length and insert into the underside channel of
each Bar end as shown.
24
25
26
27
-20mm
23