Load the Tape
7
POWER SWITCH
OUTLET
AC CORD
INLET
remove the tape
◆
Plug in the AC CORD to the AC CORD INLET.
◆
Make sure the POWER SWITCH is off then plug into an appropriate
grounded AC outlet.
◆
Turn the POWER SWITCH on.
When the POWER SWITCH is turned on, a buzzer will has a sound.
At this moment, the mode is set to MANUAL.
◆
Press the HOLD DOWN ROLLER RELEASE BUTTON.
◆
Place a roll of tape in the machine.
◆
Hold the tape by adjusting the TAPE HOLDERS.
Adjust the TAPE HOLDERS to a proper width, slide the TAPE HOLDER
ADJUST LEVER from the front to the rear of the machine then close it.
The TAPE HOLDERS should hold the roll lightly in the center of the cavity
of the machine.
This is very important because it keeps the tape in the center.
The tape passes over the SENSOR in front of the BLADE UNIT.
To support a larger roll of tape, pull the LOWER HOLDER out.
◆
Put the tape on the TAPE FEED ROLLER.
◆
Press the FWD BUTTON until the tape comes out from the TAPE OUTLET.
When using a strong sticky adhesive tape, pull a little bit tape out in
positioning into the TAPE INLET.
Press the FWD BUTTON continuously for a few seconds, also help the
tape in positioning in the TAPE INLET.
◆
After the tape is loaded and the TAPE HOLDERS are adjusted, close the
HOLD DOWN ROLLER UNIT.
◆
Press the START BUTTON.
Remove the first piece of tape and discard it.
Now your ZCUT-9GR is ready to use.
Always use Tweezers to remove tape.
Whenever set the tape, make sure that
adhesive side of tape is always faced down.
◆
When you take the roll of tape out from the machine, pull the tape
backward and pressing REV BUTTON.
