Programing Function
operating example
in the case of 6 different cut length setting
in the case of zero setting for E. F.
Function that cuts the material registered from A to F accordingly.
As refer to the following figure, operation will keep working.
This function may apply every mode.
◆
Please follow the instruction on page 7.
◆
Set the cutting length from A to F as you prefer.
◆
Please set the cutting length in ZERO for between B to F if not necessary.
Then skip the position registered with ZERO accordingly and operate
repeatedly.
◆
Apply the cutting length to your first cutting.
◆
Press AUTO/MANUAL BUTTON more than 1 second.
Then [ . ] will appear on the lower right of Alphabet.
◆
Press AUTO/MANUAL button and select AUTO MODE or MANUAL MODE.
◆
Press START BUTTON and tape is ready to take.
When setting MANUAL MODE, the next cutting length will be desplayed.
When setting AUTO MODE, the next cutting tape is ready to take with
displaying the cutting length.
◆
When discontinuing Program Function, please press AUTO/MANUAL
BUTTON longer and make sure that [ . ] is eliminated.
◆
Please take the following procedure when using P MODE or L MODE.
After setting Programing Function, press SELECT BUTTON and P will be
displayed.
Set the number of cutting and press START BUTTON.
Material will be cut until the number reaches ZERO.
◆
After setting P MODE or L MODE, press AUTO/MANUAL BUTTON if you
want to have Programing Function.
10
Set a cutting length
Programing Function setting
AUTO/MANUAL setting
Use with P MODE or L MODE
A
～
u
：
A 100mm
Press more
than 1 second
Buzzer sound
Setting
example
Confirm [ . ] description
Display the first cutting length
Press more
than 1 second
P MODE
MANUAL MODE
AUTO MODE
L MODE
Number of
cutting setting
