VX-5R O
PERATING
M
ANUAL
7
A
NTENNA
I
NSTALLATION
The supplied antenna provides good results over the entire frequency range of the trans-
ceiver. However, for enhanced base station medium-wave and shortwave reception, you
may wish to connect an external (outside) antenna.
The supplied antenna consists of two sections: the “Base Antenna” (used for operation
above 50 MHz), and the “Extender Element” (used for monitoring of frequencies below 50
MHz).
To install the supplied antenna
Hold the bottom end of the antenna, then screw it onto the mat-
ing connector on the transceiver until it is snug. Do not over-
tighten by use of extreme force.
When operating the
VX-5R
on frequencies lower than the 50
MHz band, disconnect the antenna cap from the base antenna
then screw the Extender Element onto the Base Antenna.
Notes:
¦
Never transmit without having an antenna connected.
¦
When installing the supplied antenna, never hold the upper
part of the antenna while screwing it onto the mating con-
nector on the transceiver.
¦
If using an external antenna for transmission, ensure that
the SWR presented to the transceiver is 1.5:1 or lower.
¦
Take care not lose the antenna cap when removing it from
the Base Antenna.
B
ELT
C
LIP
I
NSTALLATION
To install the Belt Clip, first place the loop of the Hand Strap into the groove at the top of
the Belt Clip, and run the loop of the strap around the round mounting ridge for the Belt
Clip. Now insert the mounting screw through the belt clip, and affix it snugly to the mount-
ing hole on the back of the transceiver, being careful not to allow the Hand Strap to become
mis-aligned.
Installation of Accessories
