Yaesu VX-177, Operating Manual

Page: 35 / 88

VX-177 O
PERATING
M
ANUAL
33
M
EMORY
M
ODE
M
EMORY
B
ANK
O
PERATION
The large number of memories available in the VX-177 could be difficult to utilize without
some means of organizing them. Fortunately, the
VX-177
includes provision for dividing
the memories into as many as ten Memory Groups, so you can categorize the memories in
a manner convenient to you.
Assigning Memories to a Memory Bank
1. Recall the memory channel to be assigned to a Memory Bank.
2. Press and hold in the [ VFO
(
PRI
)] key for one second, then ro-
tate the DIAL knob to select the Memory Bank number you want
as the Memory Bank for this channel (“
BANK 1
” ~
“
BANK10
”).
3. Press and hold in the [
F
]
key for one second to copy the memory
channel data into the Memory Bank.
1) You may assign one memory channel into multiple Memory Banks.
2) The PMS memory channels (L1/U1 through L10/U10) may not be as-
signed to a Memory Bank.
Memory Bank Recall
1. Press the [ MR
(
SKIP
)] key, if needed, to enter the Memory Recall mode.
2. Press and hold in the [ VFO
(
PRI
)] key, then rotate the
DIAL
knob to select the desired Memory Bank (“
BANK 1
” through
“
BANK10
”).
3. Press the [ MR
(
SKIP
)] key momentarily; now, as you rotate the
DIAL
knob to select memories, you will observe that you can
only select memory channels in the current memory bank. The
“
” indication will appear at the left side of the frequency
display while operating within a Memory Bank.
4. To change to another Memory Bank, press and hold in the [
VFO
(
PRI
)] key, rotate the
DIAL
knob to select the new Memory Bank, then press the [
MR
(
SKIP
)] key momentarily.
5. To exit from Memory Bank operation, select “ NOBANK ” in step 4 above. You are
now in the “standard” Memory Recall mode, without utilization
of the Memory Banks. The memories stored in the various Banks
will remain in those banks, however; you do not need to store
them again.
Removing Memories from a Memory Bank
1. Recall the memory channel to be removed from a Memory Bank.
2. Press and hold in the [
VFO
(
PRI
)] key for one second, then press and hold in the [
F
]
key
to remove the memory channel data from the Memory Bank.