page 3
MARK-V FT-1000MP Operating Manual
S
PECIFICATIONS
General
Rx Frequency Range:
100 kHz - 30 MHz
Tx Frequency Ranges:
160 - 10m (Amateur bands only)
Frequency Stability:
±0.5 ppm (after 1 min. @ 25 ° C)
±0.25 ppm (after 1 min. @ 25 ° C, w/TCXO-6)
Operating Temperature Range:
–10 ° C ~ +50 ° C
Emission Modes:
LSB, USB, CW, FSK, AFSK, AM, FM
Frequency Steps:
0.625/1.25/2.5/5/10 Hz for SSB,CW, RTTY & Packet;
100 Hz for AM and FM
Antenna Impedance:
50 Ohms, unbalanced
16.6 - 150 Ohms, unbalanced (Tuner ON, TX only)
Power Consumption:
13.8 VDC
30 VDC
Rx (no signal)
2.3 A
–
Rx (signal)
2.7 A
–
Tx (200 W)
2.2 A
14.5 A
Supply Voltage:
30 VDC and 13.8 VDC (FP-29)
Dimensions (WHD):
410 x 135 x 347 mm ( 16 x 5.3 x 13.7 inch)
Weight (approx.):
14 kg. (31 lbs)
Transmitter
Power Output:
Adjustable up to 200 watts (50 watts AM carrier),
Class A mode (SSB): 75 watts maximum
Duty Cycle:
100% @ 100 watts, 50% @ 200 watts (FM & RTTY, 3-minute Tx)
Modulation Types:
SSB: J3E Balanced, AM: A3E Low-level (early stage),
FM: F3E Variable reactance, AFSK: J1D, J2D Audio frequency shift keying
Maximum FM Deviation:
± 2.5 kHz
FSK Shift Frequencies:
170, 425, and 850 Hz
Packet Shift Frequencies:
200 and 1000 Hz
Harmonic Radiation:
Better than –60 dB (Typical)
SSB Carrier Suppression:
At least 40 dB below peak output
Undesired Sideband Suppression:At least 55 dB below peak output
Audio Response (SSB):
Not more than -6 dB from 400 to 2600 Hz
3rd-order IMD:
–31 dB @ 200 watts PEP, or better
Class A mode: –50 dB @ 75 watts PEP (Typical)
Microphone Impedance:
500 to 600 Ohms
Receiver
Circuit Type:
Quad-conversion superheterodyne (triple conversion for FM)
Intermediate Frequencies:
Main Rx; 70.455 MHz/8.215 MHz/455 kHz, Sub Rx; 47.21 MHz/455 kHz
Sensitivity:
Modes
0.5 - 1.8 MHz
1.8 - 30 MHz
SSB/CW (2.0 kHz)
2 µV
0.16 µV
AM (6 kHz)
13 µV
2 µV
FM
–
0.5 µV
(with preamp on, IDBT on, SSB/CW/AM for 10 dB S/N, FM for 12 dB SINAD,
0 dBµ = 1 µV)
Selectivity (–6/–60 dB):
Band Width
Modes
Minimum –6 dB BW
Maximum –60 dB BW
2.4 kHz
all except FM
2.2 kHz
4.2 kHz
2.0 kHz
all except FM
1.8 kHz
3.6 kHz
500 Hz
CW/RTTY/Packet 500 Hz
1.8 kHz
250 Hz
CW/RTTY/Packet 250 Hz
700 Hz
AM (Wide)
4 kHz
14 kHz
FM
8 kHz
19 kHz
IF Rejection (1.8 ~ 30 MHz):
80 dB or better (Main Rx), 60 dB or better (Sub Rx)
Image Rejection (1.8 ~ 30 MHz):
80 dB or better (Main), 50 dB or better (Sub)
Maximum Audio Output:
2.0 W into 4 Ohms with <10% THD
Audio Output Impedance:
4 to 8 Ohms
Specifications are subject to change, in the interest of technical improvement, without notice or obligation.
