page 24
MARK-V FT-1000MP Operating Manual
19. EDSP Filters
(A) APF
Selects and indicates the bandwidth for the EDSP
CW audio peaking filter. Pressing the
[APF] switch se-
lects the bandwidth to be used for the EDSP CW audio
peaking filter, with available selections of 240(Hz)/
120(Hz)/60(Hz)/DATA (DATA is an optimized bandwidth
for FAX, PACKET or SSTV operation, user-optimized
via the Menu), or “OFF,” and the indicator changes ac-
cording to the bandwidth selected. The most narrow
setting is highly useful for very-weak-signal CW work.
(B) NR
Selects and indicates the setting of the EDSP Noise
Reduction feature. Pressing the [NR] switch selects
one of four EDSP noise reduction settings, and the
indicator changes according to the selection chosen
(choose the selection providing the most effective re-
duction of noise under current operating conditions).
(C) CONTOUR
Press one of these four switches to select the de-
sired EDSP (C
ONTOUR
) filter.
: Low Cut Filter (
High-frequency emphasis
)
Pressing this button activates the EDSP Low Cut
Filter; the CONTOUR LED will glow
green
.
:Mid Cut Filter (
High- & Low-frequency emphasis
)
Pressing this button activates the EDSP Medium
Cut Filter; the CONTOUR LED will glow
orange
.
: High Cut Filter (
Low-frequencies emphasis
)
Pressing this button activates the EDSP High Cut
Filter; the CONTOUR LED will glow
red
.
OFF:
EDSP filter is off; the CONTOUR LED will
go out
.
20.MODE Selection Buttons
These momentary buttons select the operating
mode, indicated by the LED in each button. Pressing
AM, CW, RTTY, or PKT multiple times will switch be-
tween the alternate operating features that can be used
by these modes (covered later). Also, when you press
and hold in the [PKT] key for one second, the user-
programmed custom function setting mode will be ac-
tivated.
21.CLASS-A Button
This button changes the final amplifier operating
mode to
Class-A
. When operating the final amplifier
in the
Class-A
mode, the maximum output power will
be reduced to approximately 75 watts, and the LED
inside this button will glow red. Operating SSB in
Class-
A
yields an ultra-clean signal waveform.
22.FAST Button
For fast tuning, press this button (the “FAST” icon
will appear), then rotate the main or sub tuning knobs
(or press the UP(
p
) or DOWN(
q
) button). The tuning
rate will increase ten times.
F
RONT
P
ANEL
C
ONTROLS
