69
Scanning
Searching for signals
7
Rotate the DIAL to tune to the desired upper scanning limit frequency.
Tune in to the frequency to set for the upper limit (433.700 MHz).
8
Press and hold
for over one second.
The MEMORY WRITE screen appears.
9
Rotate the DIAL to select
[UP1]
.
Tip
A name tag may also be assigned to each memory channel ( page 56).
10
Press
.
The display returns to the previous operating screen, and shows the registered
frequency and memory channel number.
Lower limit frequency LP1
Upper limit frequency UP1
Scanning the programmable memory channels
1
Press
to switch to memory mode.
2
Recall the upper or lower frequency PMS memory channel.
3
Press and hold
[UP]
or
[DWN]
on the microphone for over one second.
Programmable memory scanning will begin.
Tips
• To cancel programmable memory scanning, press
[PTT]
on the microphone (this does not
cancel PMS mode).
• To cancel PMS mode, when programmable memory scanning stops, press
.
• The squelch level can be adjusted using the following procedure even while scanning.
Press
. → Rotate the DIAL.
Caution
If the upper and lower PMS frequencies are not set correctly, the programmable memory scan will not
function.
Tip
You can assign
[SCAN]
to one of the
[P1]
to
[P4]
keys on the microphone using the Setup
MENU
[8 CONFIG]
→
[10 MIC PROGRAM KEY]
. For details on assigning a function to the
[P1]
to
[P4]
keys, see “Setting the program keys on the microphone (10 MIC PROGRAM
KEY)” on page 138. For operations using
[P1]
to
[P4]
, refer to the following.
1 Press
to switch to memory mode.
2 Recall the upper or lower frequency PMS memory channel.
3 Press one of the
[P1]
to
[P4]
keys on the microphone to which [SCAN] is assigned.
