62
Scanning
Scanning
Searching for signals
The FTM-100DR/DE is equipped with a scanning function to search for memory
channels and frequencies with active signals.
Scanning can be performed using the following 5 methods:
●
VFO scan
Scan in VFO mode.
●
All Memory Channel Scan
Scan for all memory channels.
●
Select Memory Channel Scan
Scan for the specified memory channels.
●
Skip Memory Channel Scan
Skip the specified memory channels when scanning.
●
Programmable Memory Channel Scan (PMS)
Scan for the programmable memories.
VFO scan
1
Select the band to be scanned, and then switch to
VFO mode.
2
Press and hold
[UP]
or
[DWN]
on the microphone for
over one second.
Pressing
[UP]
scans in the higher frequency
direction.
Pressing
[DWN]
scans in the lower frequency
direction.
During scanning, the decimal point of the frequency
display blinks.
Once the transceiver receives a signal, the
transceiver continuously receives it until the signal
disappears, and restarts scanning 2 seconds after
the signal disappears.
Tips
• The scanning direction (UP/DOWN) can be set from
[5 SCAN]
→
[2 SCAN DIRECTION]
in the Setup menu. This scanning direction setting is applied for scanning performed by
pressing one of the
[P1]
to
[P4]
keys on the microphone to which
[SCAN]
is assigned in
advance from
[8 CONFIG]
→
[10 MIC PROGRAM KEY]
in Setup menu.
• The scanning direction can be changed by pressing and holding
[UP]
or
[DWN]
on the
microphone for over one second, or by rotating the DIAL while scanning.
• The operation performed after the scan stops on a signal, can be set from
[5 SCAN]
→
[3
SCAN RESUME]
in the Setup menu (refer to the next page).
• The squelch level can be adjusted even during scanning, by pressing
, and then
rotating DIAL.