Yaesu FTDX5000 CAT BOOK, Operating Manual

Page: 132 / 148

Page 130 FT
DX
5000 O
PERATING
M
ANUAL
M
ENU
M
ODE
108 ROUT HEADPHN
Function : Selects one of three audio mixing modes when
using headphones during Dual Receive operation.
Available Values : SEPARATE / COMBINE1 /
COMBINE2
Default Setting : SEPARATE
SEPARATE: Audio from the VFO-A receiver
is heard only in the left ear, and
VFO-B receiver audio solely in
the right ear.
COMBINE1: Audio from both VFO-A and
VFO-B receivers can be heard
in both ears, but VFO-B audio
is attenuated in the left ear and
VFO-A audio is attenuated in
the right ear.
COMBINE2: Audio from both VFO-A and
VFO-B receivers is combined
and heard equally in both ears.
105 A3J LSB CAR
Function : Adjusts the receiver carrier point for the LSB
mode.
Available Values : –200 Hz ~ 200 Hz (10 Hz/steps)
Default Setting : 0 Hz
106 A3J USB CAR
Function : Adjusts the receiver carrier point for the USB
mode.
Available Values : –200 Hz ~ 200 Hz (10 Hz/step)
Default Setting : 0 Hz
RX AUDIO G
ROUP
107 ROUT AGC SLP
Function : Selects the gain curve of the AGC amplifier.
Available Values : NORMAL / SLOPE
Default Setting : nor
NORMAL: The AGC output level will follow a lin-
ear response to the antenna input level,
while AGC is activated.
SLOPE: The AGC output level will increase at 1/
10 the rate of the antenna input level,
while AGC is activated.
NORMAL
Input Signal
Au
d
io
O
ut
pu
t
SLOPE
MODE-SSB G
ROUP
RX GNRL G
ROUP
109 RGEN IF OUT
Function : Enables/Disables the 9 MHz RX IF signal from
the rear panel IF OUT jack.
Available Values : DISABLE / ENABLE
Default Setting : DISABLE
110 RGEN MNB LVL
Function : Adjusts the noise blanking level of the VFO-A
IF noise Blanker.
Available Values : 0 ~ 100
Default Setting : 50
111 RGEN MNB WDTH
Function : Adjusts the bandwidth for the longer-duration
pulse noise of the VFO-A IF noise Blanker.
Available Values : 0 ~ 100
Default Setting : 50