Yaesu FT DX 9000D - COMPUTER AIDED TRANSCEIVER, Operation Manual

Page: 138 / 156

Page 136 FT
DX
9000D O
PERATION
M
ANUAL
M
ENU
M
ODE
045. CW AUTO MODE
Function : Enables/disables CW keying while oper-
ating on SSB.
Available Values : OFF/50MHz/ON
Default Setting : OFF
OFF: Disables CW keying while operating on
SSB.
50MHz: Enables CW keying only while operating
SSB on 50 MHz (but not HF).
ON: Enables CW keying while operating on SSB
(all TX bands).
Note : This feature allows you to move someone from
SSB to CW without having to change modes on the
front panel.
046. CW BFO
Function : Sets the CW carrier oscillator injection side
for the CW mode.
Available Values : USB/LSB/AUTO
Default Setting : USB
USB: Injects the CW carrier oscillator on the USB
side.
LSB: Injects the CW carrier oscillator on the LSB
side.
AUTO: Injects the CW carrier oscillator on the LSB
side while operating on the 7 MHz band and
below, and the USB side while operating on
the 10 MHz band and up.
047. CW BK-IN
Function : Sets the CW “break-in” mode.
Available Values : SEMI/FULL
Default Setting : SEMI
SEMI: The transceiver will operate in the semi break-
in mode. The delay (receiver recovery) time
is set by the front panel’s
CW DELAY knob.
FULL: The transceiver will operate in the full break-
in (QSK) mode.
048. CW WAVE SHAPE
Function : Selects the CW carrier wave-form shape
(rise/fall times).
Available Values : 1/2/4/6 msec
Default Setting : 4 msec
049. CW WEIGHT
Function : Sets the Dot:Dash ratio for the built-in elec-
tronic keyer.
Available Values : (1:) 2.5 ~ 4.5
Default Setting : 3.0
050. CW FREQ DISPLAY
Function : Frequency Display Format for the CW
mode.
Available Values : DIRECT FREQ/PITCH OFFSET
Default Setting : PITCH OFFSET
DIRECT FREQ: Displays the receiver carrier fre-
quency, without any offset added.
When changing modes between
SSB and CW, the frequency display
remains constant.
PITCH OFFSET: This frequency display reflects the
added BFO offset.
051. PC KEYING
Function : Enables/disables CW keying from the
“DATA IN” terminal on the rear panel’s PACKET jack
while operating on the CW mode.
Available Values : DISABLE/ENABLE
Default Setting : DISABLE
052. QSK
Function : Selects the time delay between when the
PTT is keyed and the carrier is transmitted during
QSK operation when using the internal keyer.
Available Values : 15/20/25/30 msec
Default Setting : 15 msec
MODE-CW G
ROUP