Repeater Shift
When a repeater shift is active, either
or
ap-
pears in the display. If neither appears when tuned to
a repeater output frequency, you can activate the
shift manually:
Hold the knob down for second, turn it to select
, then, press it to display the current
shift.
Repeater Input Track
If you would like to view the repeater input frequency
along with the output, and have it track as you tune
channels, this can be done using the sub-display:
Hold the knob down for second, turn it to select
, then press it to display the default
setting
Turn the knob one click to enable this feature
then press the
to accept your change, and
exit.
SAVE
Press the knob momentarily, and turn it to set
repeater shift direction
or
Press the
to accept your change and exit
Keypad
Shortcut: Press
turn the knob
to select the desired shift, then press the PTT to exit.
Tone Burst
For repeaters using
burst tone
access, you
can configure the switch below the
to sends the
tone when pressed. See page 54 for details.
The display will show the input frequency
tracking
the output as you tune. During transmit, the repeater
output appears in the sub-@splay.
Repeater Input Monitor
With a repeater split activated, you can
temporarily
reverse tx and rx frequencies by pressing
Use
this to check a signal’s strength on a repeater
input
frequency (to see if you can work them direct).
Either
or
blinks while reverse split is selected. Press
again to return to the normal shift direction.
