Let’s start by setting the receiver squelch:
Hold
(> 0.5 sec.) the knob down until the beep
sounds, then turn the knob (if necessary) to select
-or-.
----
funqtion #
S A V E
- - -
The name or abbreviation at the left is the function
title, with its number displayed to the right. You can
turn the knob to scroll through all 32 functions.
Momentarily pressing the knob shows the default
setting for the displayed function (in this case it is
the squelch level, which ranges from 0 to 15):
setting
function
SAVE
Rotate the knob a click or two past the point where
channel noise is muted, then exit the menu list by
simply pressing the PTT (the radio does not trans-
mit). The display reverts to show channel data.
Note Pressing the knob with a menu active replaces
the function number (at the right in the sub display)
with either a number
letter or abbreviation
or a symbol
In some cases the function
name (at the left) may also change, to describe the
setting more clearly.
Follow the instructions carefully when starting out,
until you become familiar with the abbreviations and
symbols used with each menu function and its asso-
ciated settings.
Things to remember...
The procedure just covered is used throughout the
manual to access functions and change settings as
desired. Once again, t h e three basic
l
Hold the knob down to recall the
tnenu
list, then
turn
the knob to select the desired
tnenu function
(number).
l
Press
the knob to display the various
function set-
tings
or state, then
turn
the knob to change or select
it as desired.
l
Press the
PTT to save the change and
exit.
