— 25 —
VII. Reset of Settings and Hardware Reset
Insert the paper clip (at a right angle to the device face) in the small hole
in the end plate of the Gateway. The LED of the Gateway will constantly shine red
when the hidden button under the hole is pressed.
Wait 2-3 seconds and the LED will change from red to green. Release the button
to reset the Device’s settings. Otherwise, the LED will become red 2-3 seconds later.
Keep the button pressed ten seconds more, and the LED becomes green. Release
the button to complete a hardware reset of Device. Alternatively, wait two seconds,
and the LED color returns to red.
Note that nothing happens if you release the button when the LED signal is red.
The settings reset occurs if you release the button during the first green light period,
and the hardware reset occurs on the second period.
During settings reset, the Device changes all settings to factory values (returns
to Access Point Mode, network SSID to “YDWG”), and the Device will produce fast
green flashes for 2-3 seconds, then reboot.
During hardware reset, the Gateway returns to the firmware version programmed
at the factory (the Device always keeps a copy of this version in EEPROM)
and to the factory settings. LED signals during firmware updates are described
in chapter IX.
Hardware reset is normally not required. It can be used for firmware rollback.
