![background image](http://html1.mh-extra.com/html/yacht-devices/nmea-2000-ydbm-01/nmea-2000-ydbm-01_user-manual_3082494049.webp)
— 49 —
It has 6 steps (shown at Figure 1), which are indicated by a special 6-flash LED sequence emitted every
20 seconds (R on the drawing is RED signal, G – GREEN). You can also get know the current state with
MicroSD card (see Section IX), first lines of YDBMSAVE.TXT contains the current state of synchronization
and the date/time when it was started. Alternatively, you can enter the command YD:FULL_SYNC without
parameters or the command YD:SOH (see IX.2).
Calculations must be on to perform the Full Synchronization (command YD:CALCS ON or CALCS=ON
in the YDBM.TXT file, see Section IX).
To run the process, enter the command YD:FULL_SYNC ON (see IX.2) or type FULL_SYNC=ON
in the YDBM.TXT file (see IX.1). After that, the Device will flash RED-RED-RED-RED-RED-GREEN
(RRRRRG) every 20 seconds, and the state will be switched to «Pending». Then you should fully
charge your battery (see X.1 for details about full charge) until the flash sequence changed to RRRRGG
and the state is switched to «Started».
Figure 1. Full synchronization process
Summary of Contents for NMEA 2000 YDBM-01
Page 66: ......