— 32 —
Section
Parameter
Notes
CALCS=OFF|ON
Factory setting: OFF
Enables or disables calculation
of the battery status information
(SoC, consumed ampere-hours, time
remaining, SoH). When this parameter
is set to OFF, only battery instance and
DC Type data are included into NMEA
2000 PGN 127506 «DC Detailed
Status». IMPORTANT: when you set
CALCS to ON, all calculation results
for SoC, consumed ampere-hours,
time remaining, SoH are automatically
reset (1).
FULL_SYNC=OFF|ON
Run/stop Full Synchronization with
the battery (see Section X).
MARETRON=OFF|ON
Factory setting: OFF
Compatibility mode of digital
switching functions for Maretron
and Carling Tech equipment (3).
SXn_a=[c t b ch]|NEVER
Digital Switching rules (see IX.3
for details)
Note (1):
It means that SoC and SoH values will be 100%, consumed Ah will be 0Ah.
If you connect a new fully charged battery after a settings reset, no synchronization
is needed. Otherwise, if you connect a battery of less than one year old, and/or partially
charged, or you do not need to monitor SoH, a Partial Synchronization is required.
For older batteries and/or credible SoH readings, you should perform a Full
Synchronization (refer to X.1 and X.2 for details).
Table 1 continued
Summary of Contents for NMEA 2000 YDBM-01
Page 66: ......
