13
14
How to Use
How to Use
How to Use
Attaching Cotton to the Head
1
Remove the cotton stopper
from the electrode head.
2
Place the cotton on top of the electrode
head and press the cotton stopper down over the cotton.
* If the cotton stopper does not fit properly on the electrode head, use a thinner
cotton.
* If the cotton is too thick, the thermal action of RF treatment may be adversely
affected and you will feel less heat.
3
Apply your regular skin lotion or gel onto the cotton.
* Make sure that the lotion or gel coats the entire surface of the treatment head.
* If using a smooth (low-viscosity) skin lotion, the feeling of warmth may
decrease.
Recommended skin lotions: RF Booster Pad/high-viscosity skin lotions
* This device is not water-proof so be sure to thoroughly wipe off any lotion or
gel left on the device with a dry cloth after each use.
Do not wash with water or other liquids.
● For how to use RF Booster Pads, please refer to the instructions
provided separately.
7
After treatment, condition your skin as necessary.
• Please apply skin cream as appropriate.
6
Press the Power/Mode button for approx. 3 seconds
to turn off the power.
• When treatment on Cool Mode has finished, the power will turn off
automatically.
8
Remove cotton from the electrode head and wipe off any
residue of skincare lotion or gel remaining on the electrode
head or cotton stopper.
* This product is not water-proof so be sure to thoroughly wipe off any lotion or
gel left on the device with a dry cloth after each use.
Do not wash with water or other liquids.
1
Remove makeup and gently cleanse your face.
• Remove oil and dirt from your skin so that it is in a clean condition prior to
treatment.
* Cool Mode can be used over makeup.
3
Press the Power/Mode button for approx. 3 seconds to turn
on the power. Select mode and intensity level.
• Select the mode using the Power/Mode button.
• Select the intensity level using the Level/Vibration button.
• Press and hold the Level/Vibration button for about three seconds to switch the
vibration function ON/OFF.
(When using Clean/Moisture Mode,)
* The device does not vibrate on EYE CARE, EMS UP, RF LED or Cool Mode.
* Intensity level cannot be selected for Eye Care/RF LED/ Cool Mode
* RF intensity level cannot be selected.
* Always select Level 1 upon the first use until you are accustomed to use.
2
Attach cotton if necessary and apply lotion onto the cotton.
●Treatment method
4
Hold the device so that you are touching the hand
electrode (silver rim) on the rear of the device.
5
Gently apply the treatment head to your skin and move the head
over the area being treated. (Refer to p.15-16 for more details)
• When the Mode is finished, the device will go into standby for 2 min. After using
the Cool Mode, the device will automatically turn off.
Either press the Power/Mode button to start the next mode, or press the
Power/Mode button for approx. 3 seconds to turn off the power.
* During use, make sure that the electrode head is firmly touching the skin.
How to Use (General Instructions)
●Precautions when using
● Be sure to move the unit on your skin while using it. Using the device
continuously on the same area may cause burns or other injuries.
● The temperature of RF may feel different depending upon the condition of
your skin and types of cosmetics used together.
● Do not use on eyelids or around the eyes (except when using the device
on Eye Care or Cool Mode)
* RF LED Mode can be used on eyelids and around the eyes. Close your eyes
and hold the device 5cm away from your eyes.
● Do not look directly into the LED light when using the device on RF LED
Mode.
● Be sure to hold the device so that your hand is touching the electrode
head.
● Recommended ambient temperature is 15°C ~ 30°C.
