Handy tips
• The filament will load better when the tip of the filament is cut at a 45° angle.
• When the printer is not in use, raise the filament spool holder and close the side cover.
Lower the filament spool
holder on the left side of
the printer until horizontal.
Use a phillips screw-
driver to loosen the
securing screws of the
filament spool ring.
(please refer to this step if the axle ring is not installed on the spool)
Install the sensor chip.
Note the orientation of
the sensor chip on the
spool ring.
Use a phillips screw-
driver to tighten and
secure the spool ring
to complete the
installation.
Separate the spool ring
from both sides of the
spool.
Place the assembled
filament spool (with
the spool ring) on
the spool holder.
Press the release arm and
push the filament all the
way to the bottom so that
the front end of the
filament is completely
inserted into the extruder
module.
2
Remove the side cover by pressing down
firmly at the center on the left side of the
cover and pushing aside the cover. (pay
attention to where you apply your force to
ensure proper dismantling) Keep the side
cover securely for future use.
1
3
Take the tip of the
filament and
insert it into the
feeding hole.
4
5
3.Installing the filament
Feed both parts of the
spool ring through the
center hole of the
spool and assemble
them together.
Retrieve the filament
spool and chip.
2.Installing the Filament spool ring
2
1
3
4
5
6
- 5 -
