Using the accessory
tools
Maintenance Tools
PET Protection cover
Usage
Application method
Scraper
Accessory tools can be used only in an
environment with guidance or moni-
toring by adult. Do not allow children
to obtain maintenance tools in unfa-
miliar situations in order to avoid
danger.
Filament should be unloaded from the extruder before cleaning the feeding path.
Care should be taken during the operation to avoid potential burn injuries.
Instructions for re-using the double-sided tape of the PET shielding:
Pieces of tape can be re-used if they were kept clean and properly maintained. However,
multiple use or dirt on the tape may reduce the strength of adhesion. Please gently
remove the PET shielding from the printer and then slowly peel away the double-sided
tape from the PET shielding. Do not pull at the tape directly. Stickiness may be restored
by cleaning it with soap water and then drying it.
Keep your hands
away from the
printing and
operations area
when the machine
is printing.
Taken off the
printing object
Once the PET protective casing has been assembled, apply double sided tape at the
specified locations. Check that the adhesion areas on the printer are clean. Peel away
the carrier film and apply slight pressure to attach the PET casing to the front of the
printer.
After print is finished, the printing object may be taken off with Scrap-
er.
Cleaning Tools
Cleaning Brush
Usage
Application method
Feeding Path Cleaning
Wire
Cleaning Wire
Clean gearwheel
After long periods of use, the
automatic feed system may
have experience unstable
extrusion of the filaments due
to buildup of residual materials
within the filament channels.
Clean Feeding Path
If the cleaning cycle does not
unclog the extruder, try clean-
ing the feeding path by useing
the feeding path cleaning wire.
Clean Nozzle
In order to prevent print quality
from impact due to residual and
accumulated filament, which
results in poor discharge.
The printer filament feed module should be
cleaned after cleaning the nozzle. To do this,
please switch off the power first.
Open the feed module cover and clean the gears
using a gear cleaning brush.
1. Switch on the power and activate the "Clean
Nozzle" function by using the software.
2. Release the extruder module (don't remove the
heating cable at the side).
3. Insert the thick cleaning wire into the feeding
path all the way down and “floss” the inside
of the nozzle to push the residue out.
4. After cleaning the feeding path, reinstall the
extruder module.
we recommend you to clean nozzle for every 25
hours of print. Please clamp the nozzle cleaning
wire with needle-nosed pliers to insert it into the
opening of the nozzle carefully for cleaning.
- 14 -
