Apr. 2017
P 16
da Vinci
Jr.1.0A
Print Bed Leveling
Standard Print Bed Leveling
B. Screwdriver (T10) for print bed leveling procedure
A. Leveling tool
The flatness of the print bed will affect the 3D print quality. There are highly recommended you do print bed calibration
regularly (CALIBRATE), then the implementation of "Print Bed Leveling" to get a more flatness print bed.
Move the Z axis back to the origin with the HOME AXES
function.
Use Jog Mode and move the Z-AXIS upwards by 10 mm.
Manually move the printing module to the right side to prevent affecting its calibrated position. At the same time,
place the leveling tool onto the bed right under the Z axis.
1
2
3
JOG MODE
X-AXIS
Y-AXIS
Z-AXIS
Z-AXIS [ OK ]
>>
EXIT
[ 0.1mm ]
001mm
[
－
] 010mm [
＋
]
HOME AXES
ARE YOU SURE?
NO
YES
Preparation of Tools
Loosen the 5 marked screws in order as shown in the figure.
Do not loosen the screws other than the marked ones. (Do
not remove the screws. Just loosen the screws slowly. )
Move the Z axis downward (in 1mm interval) with the
JOG MODE function until the X-axis bracket aligns
with the leveling tool.
Visually check if the leveling tool is aligned with the
X-axis bracket, and then tighten the 5 loosened screws
again.
Ensure screw was tightened and calibrate print bed
again. Select "UTILITIES" > "CALIBRATE" > "YES",
bed leveling was finished.
4
5
6
7
JOG MODE
X-AXIS
Y-AXIS
Z-AXIS
Z-AXIS [ OK ]
>>
EXIT
[
－
]
▲
[ 0.1mm ]
▲
[
＋
]
001mm
010mm
D
B
A
C
E
