65
2.2 Connection and installation of titrator and magnetic stirrer TM 235
The low voltage cable of the power supply TZ 1853 has to be plugged in to the 12 V socket „in“, (see Fig. 12 back
panel, chapter. 2.7), on the back panel of the titrator. Then plug the power supply into the plug socket.
Fig. 2a
Place the power supply easily accessable in order to be able to remove the titrator anytime easily from the power
circuit.
As a rule, the TM 235 magnetic stirrer is arranged to the right of the piston burette. The magnetic stirrer is
connected to the 12V
out
-socket in the rear panel of the piston burette using the TZ 1577 connection cable
(scope of delivery of the basic device) (cp. ‘Back panel’ illustration, chapter 2.4). The stand rod (scope of delivery
of the basic device) is screwed into the thread; subsequently the Z 305 titration clamp (scope of delivery of the
basic device) is installed (fig. 2b).
Fig. 2b
Summary of Contents for SI Analytics TITRATOR TitroLine 7500 KF
Page 1: ...TitroLine 7500 KF trace TITRATOR OPERATING INSTRUCTIONS...
Page 57: ...Notes...
