Xylem GOULDS e-HME Series, Instruction Manual, Page: 23 / 52

Item Terminals Ref. Description Notes
Analog input
0-10V P2IN/S+ 7 Actuator mode 0-10 V
input
0-10 VDC
P2C/S- 8 GND for 0-10 V input GND, electronic
ground (for S+)
External Pressure
sensor [also
Differential]
P1+ 9 Power supply external
15 VDC
15VDC,
Ʃ
max. 100
mA
P1- 10 External sensor 4-20
mA input
4-20 mA
External Start/Stop START 11 External ON/OFF
input reference
Default short circuited
Pump is enabled to
RUN
STOP 12 External ON/OFF
input
External Lack of Water LOW+ 13 Low water input Default short circuited
Lack of water
detection: enabled
LOW- 14 Low water reference
Communication bus B1 15 RS485 port 1:
RS485-1N B (-)
ACT, HCS control
mode: RS 485 port1
for external
communication
MSE, MSY control
mode: RS 485 port 1
for multi-pump
systems
A1 16 RS485 port 1:
RS485-1P A (+)
GND 17 Electronic GND
Communication bus B2 18 RS485 port 2: RS485
port 2: RS485-2N B (-)
active only with
optional module
RS 485 port2 for
external
communication
A2 19 RS485 port 2: RS485
port 2: RS485-2P A
(+) active only with
optional module
GND 20 Electronic GND
Table 8: 3~ I/O terminals
Item Terminals Ref. Description Notes
Fault signal C 25 COM - error status
relay
In case of power
cables: use the M20
cable gland
NO 24 NO - error status relay
Motor running signal C 23 Common contact In case of power
cables: use the M20
cable gland
NO 22 Normally open
contact
Auxiliary Voltage
Supply
15V 21 Auxiliary voltage
15 VDC
15VDC, Ʃ max. 100
mA
Analog input
0-10V S+ 20 Actuator mode 0-10 V
input
0-10 VDC
S- 19 GND for 0-10 V input GND, electronic
ground (for S+)
External Pressure
sensor [also
Differential]
P1+ 18 Power supply external
15 VDC
15VDC,
Ʃ
max. 100
mA
P1- 17 External sensor 4-20
mA input
4-20 mA
4 Installation
Smart Pump Range INSTRUCTION MANUAL 21