5.3 Common procedures
5.3.1 Set the date and time
1. Go to Settings > Global > Date and time > Change date/time.
2. Change to the correct date and time.
5.3.2 Change the communication settings
1. Go to Settings > Communication settings.
2. Change the applicable parameters.
5.3.3 Acknowledge an alarm
The alarm LED and the status lamp turn red or yellow when there is an active alarm. The
user interface also shows the active alarm, and the alarm class and type.
Press the Acknowledge alarms button.
All active alarms are acknowledged.
For more information, see
on page 33 and
5.3.4 Reset the service alarm
The Service alarm alarm must be reset manually.
1. Go to Settings > Alarm > Service alarm > Enabled > Disabled.
2. Confirm.
The alarm is disabled.
3. Go to Settings > Alarm > Service alarm > Interval.
4. Set the interval.
5. Confirm.
6. Go to Settings > Alarm > Service alarm > Enabled > Enabled.
7. Confirm.
The alarm is enabled.
5.3.5 Change the alarm settings
1. Go to Settings > Alarm.
2. Select the alarm.
3. Select the parameter.
4. Configure the parameter.
For more information, see
5.3.6 Change the start condition and stop condition
1. Check that the controller is in the AUTO MODE.
2. Go to Settings > Pump control > Start condition to change the start condition of the
control mode.
3. Go to Settings > Pump control > Stop condition to change the stop condition of the
control mode.
5.3.7 Adjust the pause time
1. Go to Settings > Pump control > Minimum pause time to change the minimum pause
time.
2. Go to Settings > Pump control > Maximum pause time to change the maximum pause
time.
5 System Setup and Operation
DCM 711 Installation, Operation, and Maintenance Manual
25
