XVME-976 Adapter Module
1-10
7.
Remove blank front panel assembly from XVME-976 (save for possible
future use).
8.
Connect the cables from the front panel kit to the Type B expansion
module.
9.
Remove the two screws opposite the PC/104 connector and fold the
mylar shield back to expose the standoffs. Be sure to retain the screws
for use in securing the PC/104 module to the XVME-976.
10.
Align the PC/104 connectors of the XVME-976 with the corresponding
connectors on the Type B module.
11.
Gently press the two boards together.
Do not bend or twist the XVME-
976.
12.
Fold the mylar shield down (over the solder side of the expansion mod-
ule).
13.
Insert the two screws removed in Step 9.
14.
Attach the new front panel assembly, if provided, to the XVME-976
with the four screws removed in Step 6.
15.
Align the connected modules (with the XVME-976 on the right) on the
plastic guides in the slots.
16.
Gently push the modules to the rear of the chassis until the P1 and P2
connectors engage.
17.
Tighten the screws on the front panel of the XVME processor module to
secure the connected modules into place.
The installation is complete.
Summary of Contents for XVME-976/202
Page 48: ......
Page 50: ...XVME 976 Adapter Module 4 4 2 Figure 4 1 Connector and Jumper Locations...
Page 72: ......
Page 84: ......
