XVision XSD27ZIR, User Manual

Page: 8 / 36

XSD27ZIR
8
6. Install black liner and Pan/Tilt Module 7. Install down cover
Unscrew the two M4 screw on down cover ring. Push up
the down cover into the housing and then fasten down
cover with two M4 screws.
NOTE: Apply lube to the O-ring for external mounting
■
C O R N E R M O U N T
Check carefully to make sure the wall is firm and does not peel off. It is required that the wall can withstand 8 times weight of the dome
set.
1. Mark the fastener positions.
Use the corner mount base as the template to mark
the mounting positions on wall.
2. Install base.
Feed the Power/RS485 Video cables through the hole of
corner mount base and use M8 nuts to fasten corner base
on the mounting surface.
NOTE: Put cables through the wall of aside the corner
base
3. Install bracket.
Put cables through the cavity of bracket and fasten
bracket on base
4. Install housing
Feed the cables through the hole on top of the housing. Align
the dome casing to the bracket and fix with 2 M5 screws as
shown.
NOTE: Apply water-proof tape to the thread in the case of
outdoor dome