XVision XSD27ZIR, User Manual

Page: 14 / 36

XSD27ZIR
14
OPERATION INSTRUCTIONS
The Speed Dome can be controlled through combination of hot keys on a keyboard controller. It can also be controlled through the OSD
menu. The OSD menu can be activated by preset #95 call or double calling preset 1 (call twice within 5 seconds). Preset calling can be
done through a keyboard controller or any other device (e.g. a computer) that can send commands to the speed dome.
OSD menu operations are specified as follow:
■
PREHEATING SCREEN
When power on the dome and system temperature is under
-15C/5F
，
following screen shows up:
Outer Temp: -030C/-022F
System Temp: -020C/-004F
Fan Speed: 6480rpm
System Under
-15C/5
F
System Heating Up
Please Wait…
The system will heat up until the system temperature is above
-15C/5F. System starts to boot up after heating up finishes.

< Outer Temp >
Environment temperature XXC/XXF
C: ° Celsius
；
F: ° Fahrenheit

< System Tem >
System inner temperature

< Fan Speed >
The rotating speed of the fan.
■
BOOT-UP SCREEN
When power on or restart the dome, the boot up information
will display on screen and then the dome will begin self-testing.
“System booting up…” will show on the screen until “boot-up
success” shows up. The whole boot up process lasts about 40
seconds. This screen display disappears once the dome receives
any effective command.
Protocol : Ernitec
Baud Rate : 4800BPS
Camera ID : 001
Camera S/N : 8888888888
Model : -------------
Version : 8.01
Outer Temp :022C/071F
System Tem :027C/080F
Booting Up… …

<Protocol>
Dome control protocol.

<Baud Rate>
Dome control baud rate

<Camera ID>
The dome ID address set by dip switch or keyboard. (See
APPENDX I)

<Camera S/N>
Camera serial number.

<Model>
Speed dome model number

<Version>
Hardware and software version
Protocol : Ernitec
Baud Rate : 4800BPS
Camera ID : 001
Camera S/N : 8888888888
Model : -------------
Version : 8.01
Outer Temp :022C/071F
System Tem:027C/080F
Bootup Success
■
ACCESSING MAIN MENU

Display the dome’s main menu on your monitor by calling
preset 95 or calling preset 1 twice within 5 seconds.
Note: For third party keyboard controllers please read user
manuals as command to a preset may not be the same
among different manufacturers.

In case password protection is in effect, input the correct
6-bit password to enter the OSD menu. (Default password
is 123456).

To enter password, move the joystick up or down to select
number (0-9), move the joystick left or right to choose
password the digits. If the input password is wrong, the
password input window will disappear.
The OSD menu will close automatically after 1 minute
without any operation. All the settings will be saved
automatically to protect against power outage.