10
EMC/RF REQUIREMENTS
Europe—EU Declaration of Conformity:
The equipment complies according to the Radio Equipment and
Telecommunications Terminal Equipment Directive 1999/5/EC. This
equipment meets the following conformance standards:
• Safety : EN 60065:2002/A12:2011
• Health: EN 62479: 2010
• EMC : EN 301 489-1 V1.9.2
• EN 301 489-17 V2.2.1
• EN 55013: 2013
• EN 55020:2007/A11:2011
• Radio: EN 300 328 V1.8.1
FCC REQUIREMENTS
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device is comply with Class
B limits. All peripherals must be shielded and grounded. Operation
with non-certified peripherals or non-shielded cables may results in
interference to radio or reception.
MODIFICATION: Any changes or modifications not expressly approved
by the grantee of this device could void the user’s authority to operate
the device.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
MANUFACTURER’S NAME AND ADDRESS
XTZ Sound in Balance AB
Gamla Nissastigen 19, 31441 Torup, Halland, Sweden
