19
①
Go to Menu
Setup
Schedule
Motion tab.
②
The setup steps for schedule for motion based recording are similar to normal schedule
setup. You can refer to 4.4.1 Schedule for details.
Note:
The default schedule of motion based recording is 24
ⅹ
7. If you want to activate
motion based recording, you must enable motion alarm and set up schedule for motion
alarm (see Chapter 4.5.1 Motion Alarm for more details).
4.5 Alarm Configuration
Alarm configuration includes four sub menus: motion, video loss, other alarm and alarm out.
4.5.1 Motion Alarm
Motion includes two sub menus: motion and schedule. The steps to set motion alarm are as
follows:
①
Go to Menu
Setup
Alarm
Motion. Refer to Fig 4-16:
②
Enable motion alarm, set alarm hold time which refers to the time till which the system
will wait for further detection of motion. e.g. If the holding time is set to 10 seconds,
once the system detects a motion, it will go to alarm but would not detect any other
motion alarm (specific to channel) until 10 seconds. If there is other motion detected
during this period it is considered it as continuous movement, otherwise it will be
considered as a single motion.
Fig 4-16 Alarm Configuration-Motion
③
Click “Setting” button under the Trigger area. Then a window will pop up as below:
