Setup Menu
–
Failsafes
Figure 13 – Failsafes menu
You can program what happens to every output port when a failsafe
condition occurs.
Port – the port number to program
Type – how the failsafe is handled
Position – the servo pulse position to move to during a failsafe
Delay – amount of time losing the RF connection before a failsafe occurs
Live Set: Start – used to invoke the Live Active Failsafe programming
Changing the Port number will show the current failsafe settings for that
port, and allow you to then change those settings.
There are three failsafe types that are possible.
Hold
means that during a
failsafe condition the current output value will not change.
User
means that
the when a failsafe occurs, the output port value will be set to the value
show in Position.
Off
means that the servo output for that port is turned
completely off. This is required for some auto-pilots in order to think there
was a loss of signal.
Delay is the amount of time (in 1/10ths of a second resolution) that must go
by without a RF signal before invoking the failsafe system.
Live Set: Start
, this is a special option that starts the Live Active Failsafe
feature.
26
