In the primary state, keep pressing
for 2 seconds, and it shows the parameter of
At; press
to make OFF as on, and press
to start the function. When it shows "At"
flashing, the meter is performing position adjustment, and after 2 cycles of vibrating, the
inner processing unit will automatically make out the parameters of PID and finish the At.
When it's necessary to cancel the function, pressing
for 2 seconds again to make out
3 , Please refer to the following setting temperature for Common packing material:
Packing material
Set temperature
Note
Paper/polyethylene,
pure
160-180°C
This
table
for
the
common
aluminum/polyethylene
packing
material
reference
Cellophane/polyethylene
110 -130°C
choose, you must sure it according
Paper/polyethylene
170 -200°C
to
the
packing
effect
and
Polypropylene/polyethylene
120 -140°C
reliability of seals.
Attention:
When you set the temperature, horizontally seals temperature generally lower
than vertical seals temperature for 10 °C ; After the temperature achieved the appropriate
setting value, the temperature is whether appropriate according to the seal effect, if heat-seal
temperature is low and seals will not reliably, if heat-seal temperature is too high
consequently happen the corrugation, the temperature carries on the adjustment
correspondingly.
After turning on the heater switch for about 5-10 minutes, the machine can achieve the
setting temperature. The machine can run normally only after the temperature reached the
setting point exactly.
5.3 Introduction to the HMI
When getting started, it will display the screen
XtraVac RBF8 Rotary Bagger Operation, Service, & Parts Manual
XtraVac Packaging Machines
RBF8 - Rotary Bag Filling & Sealing Machine
419 E. 11th Ave. North Kansas City, MO 64116 USA
+1 800-728-2999 • [email protected]
