3
For more cool and exciting XTM Racing products, visit our website at http://xtm.globalhobby.com
Section 1: Our Recommendations
This section lists the items you will need to run and maintain your new XTM Baja Bullet RTR electric truck. As you can see, there's not
much to it!
●
Trinity Amp Max II 1500Mah Battery Pack - Part # 842006
●
Promax Black Widow AC/DC Peak Charger - Part # 350360
●
Trinity "8 Pack" AA Alkaline batteries for the transmitter - Part # 837801
●
Emerald Performance Plus 3 to clean the motor - Part # 340186
●
Adjustable wrench and # 2 phillips head screwdriver to make chassis adjustments
●
7mm socket wrench to make slipper-clutch adjustments
Section 2: Becoming Familiar with Your Baja Bullet RTR Electric Truck
Each radio system comes with crystals and stickers on the back of the transmitter and on the receiver showing which frequency the
radio operates on (either in the 27Mhz or 75Mhz band). No two radio systems can operate nearby each other if they are on the same
frequency. You can purchase transmitter and receiver crystals separately and change them if you plan on running your truck with other
people. Listed below are the frequencies available for your radio system.
Channel #
Frequency
Hitec Part # (tx/rx)
67427xx/66427xx
01
16.995
02
27.045
03
27.095
04
27.145
05
27.195
06
27.255
61
75.410
90
75.990
Through
67475xx/66475xx
Note that "xx" is the actual channel number you want
to purchase.
27Mhz
75Mhz
Battery Cover:
This cover houses the 8 AA Alkaline batteries that power the transmitter.
Crystal:
This is the frequency crystal of the transmitter. You can change crystals in both the transmitter and the receiver (in the truck)
so that you and your friends can drive at the same time. No two radio systems nearby can be on the same frequency.
On/Off Switch:
Turns the transmitter on and off. Two L.E.D.s show the power of the batteries.
Servo Reversing Switches:
Allow you to quickly and easily switch the direction the servos rotate by just flipping the switches on
the top of the transmitter.
Steering Wheel:
Controls the trucks steering. Turn the wheel to the right and the truck turns right. Turn the wheel to the left and the
truck turns left.
Throttle/Reverse Trigger:
Controls the forward and reverse speed of your truck. Pull the trigger to accelerate forward, release the
trigger to decelerate and push the trigger to go into reverse.
Trim Levers:
These levers, one for steering and one for throttle/reverse control, allow you to fine tune the servo's center by sliding the
levers on the transmitter.
