connect to the video outlet provided by our company.
Now, all the power cables and signal cables have been connected. Please check
carefully to guarantee correctness and firmness of all connections.
5.
Finally, please connect the 220V interface of our company’s provided special
adaptor to
AC220V power supply.
Part III: Setup the Functions of the Ball
3-1. Setup of Communication Protocol, Baud Rate and Address of
Constant Speed Ball
The constant speed ball has built-in Decoding PCB penal, the control of the dome
and camera lens is realized by setting up address, protocol and baud rate through the
decoding PCB penal.
1.
Address Setup
As shown in the picture 10 and picture 11, DIP-1 to DIP-6 of the 8-button coding
switches is used to setup address of the constant speed ball from 1 to 63. Control can
be realized only when address code of the constant speed ball is identical to that of the
hard disk video camera or matrix or controlling keyboard. The coding switches from
DIP-1 to DIP-6 are equivalent to a 6-bit binary figure. The state “ON” of each bit
means “1” while”OFF”means”0”. Table 2 shows states of coding switches.