D. On completing the setup of left/right limiting positions, press the two keys
“S1” and “S2” simultaneously with your forefinger and middle finger for about 2
seconds till the green indicator—D11 is off. The off state of the green indicator
suggests exit of the dome’s left/right limiting position setup. The exit of the dome’s
left/right limiting positions setup can also be realized by switching off the power and,
then, on again.
☆
Setting up the dome’s left/right limiting positions through keys on the ball set
panel
A. Once the dome is installed and power is on, the ball starts a self-check. After
the self-check, the position of the ball is the default left position of the ball. Open the
vitreous cover, find on the ball panel the two keys-”S1”, “S2”, then, press the two
keys simultaneously with your forefinger and middle finger for about 2 seconds till
the green indicator—D11 is continuously on. The continuous-on state of the green
indicator suggests entering the setup of the dome’s left/right limiting position.
B. Next, press the key “S2” on the constant speed ball panel and then release it,
then the dome begins to turn right. When the dome reaches the desired point of right
position setup, press either “S2” or “S1” and then release it, and the dome will stop
moving. If the dome goes out of the desired range, press the key “S1” on the constant
speed ball panel and release it, then the dome begins to turn left. When the dome
reaches the desired position, press either “S2” or “S1” and then release it, and the
dome will stop moving. Finally, press the key “S2” for about 2 seconds till the green
indicator glistens once. The glistening means the setup of the dome’s right limiting
position is successful.
C. Then the setup of the left position follows. Press the key “S1” on the constant
speed ball panel and then release it, then the dome begins to turn left. When the dome
reaches the desired point of left position setup, press either “S2” or “S1” and then
release it, and the dome will stop moving. If the dome goes out of the desired range,
press the key “S2” on the constant speed ball panel and release it, then the dome
begins to turn right. When the dome reaches the desired position, press either “S2” or
“S1” and then release it, and the dome will stop moving. Finally, press the key “S1”
for about 2 seconds till the green indicator glistens once. The glistening means the
setup of the dome’s left limiting position is successful.
D. On completing the setup of left/right limiting positions, press the two keys
“S1” and “S2” simultaneously with your forefinger and middle finger for about 2
seconds till the green indicator—D11 is off. The off state of the green indicator
suggests exit of the dome’s left/right limiting position setup. The exit of the dome’s
left/right limiting positions setup can also be realized by switching off the power and,
then, on again.
If the user wants to change the setup of left/right limiting positions after the
setup has been done, please refer to the adjustment setup instructions.
Remarks:
Pressing two keys together for two seconds indicates entering or exiting the
