Matrix1608A User's guide
www.xtendlan.com
22
Number:0001 OFF→Set “Auxiliary Switch 1” open by pressing down “SHIFT+MON”key, Set “Auxiliary Switch
1” close by pressing down “SHIFT+CAM”key.
17
This Function is used for the frontal terminal device with the wash brush function only.
18
.The fan and heater in the speed dome camera is always under auto temperature control status. This function
will auto start when the temperature reaches higher point or lower point.
9.4
Auxiliary Switch 2 Set
Press “MPX” or “Auto” key until LCD display as below:
6) Auxiliary#2
Number:0001 OFF→Set “Auxiliary Switch 2” open by pressing down “SHIFT+MON”key, Set “Auxiliary Switch
2” close by pressing down “SHIFT+CAM”key.
9.5
Proportion Joystick
△
! This function has been set well before the keyboard leaves the factory. The speed of the Joystick is a direct
ratio the running speed of the dome. If it is not a direct ratio; reset the keyboard joystick parameter.
Press “MPX” or “Auto” key until LCD displays:
Joy Stick Set
Tilt:000 Pan:00O
→
Display Joystick value(Up, Down, Left, Right)
Set Joystick middle value (dwelling time)
When stop on the middle part, set joystick middle status by pressing ”AREA” key.
Set joystick up limit value
Move the joystick to top (up), set its upper limit value by pressing ”SEQ” key
Set joystick down limit value
Move the joystick to bottom, set its lower limit value by pressing ”MON” key
Set joystick left limit value
Move the joystick to left side, set its left limit value by pressing ”GRP” key
Set joystick right limit value
Move the joystick to right side, set its right limit value by pressing ”Next” key
Set joystick retrorse limit value (limited for PTZ keyboard
–only)Move the middle pillar of joystick to the bottom extrorsely, set its retrorse limit value by
pressing ”Pan_A” key
Set joystick veering limit value (limited for PTZ keyboard –only)
Move the middle pillar of joystick to the bottom veer; set its veering limit value by pressing ”Pan_B”
key
See below chart for setting reference.
Operating Key
Function
Enable
Set joystick retrorse limit value
List
Set joystick veer limit value
GRP
Set joystick left limit value
Next
Set joystick right limit value
ACK
Set joystick up limit value
MON
Set joystick down limit value
SEQ
Set Joystick middle value