- 12 -
Connection by WiFi- WPS ( WiFi Protection Service )
IP Power IPM-401W support WPS function which can assist user setup the WiFi connection of
user`s router and IP Power IPM-401W automatically . Before using WPS function, please check
your WiFi router and see if there has WPS function first . There should have a button name
“WPS / QCC “ or a sign on the router for user to click easily.
Please refer following steps to setup WiFi
–WPS connection
Step 1: Power on the IPM-401W - only connect power in but do not connect the LAN cable , you
will hear one short beep in 40 seconds means IPM-401W boot successfully
Step 2: Press the
“WPS button” of your WiFi Router. ( Please check your router WPS function )
Step 3 : Press One time ( short) the
“ Reset button” of IPM-401W and then there is one long
beep which means the WPS function of IPM-401W enable .
Step 4: After few seconds , there are 2 beep : short Beep + middle beep
Which means WPS connection successfully
( If WPS connection fail , there is one long beep mean the connection fail.
Please go back to step 2 and try again )
Step 5: Power to reboot IPM-401W . There is one short beep in 45 seconds which means
IPM-401W boot up successfully .
