5
4.
MONITOR PROGRAMMING
4.1.
What’s Room Code
Each Monitor in system must be programmed with an address (
Room Code
), i.e. the
calling numbe
r.
Room Code ranges from “0001” to “9999” and each Monitor Room Code must be unique in one building.
Room Code is stored in each Monitor’s inner EEPROM memory, and does not lose even the monitor is power off.
Room Code has no relation with the location where the Monitor is installed.
Room Code is always 4 digits format, but the
Doorplate Mode
parameter in Door Station will control the digits you
have to input in Door Station keypad, to call the Monitor. If
Doorplate Mode
is set to the 2 digits mode, only 01~99
can be input (01~99 mapping Room Code range from 0001 to 0099, you must program Monitor in 4 digit format).
Please refer to:
PROGRAM > [1] Configuration > -7. Doorplate Mode
4.2.
How to acquire current Room Code
-
Connecting the Monitor with a Door Station running in Debug Mode, press the Monitor’s CALL Button, the
Door Station LCM screen will show the Monitor’s Room Code (and Door Station will call back the Monitor
automatically after 3 seconds if Auto Dial Back debug option is activated).
-
Connecting the Monitor in a system that Guard Unit works, presses the Monitor’s CALL Button, the Guard
Unit’s LCM screen will show the Monitors’ Room Code.
-
If the Monitor is color type with OSD Menu, you can get the Room Code in ABOUT Screen of OSD Menu.
-
Even if you don’t know the current Room Code, you can also program the Monitor to assign new Room Code.
4.3.
Program Monitor by means of Monitor’s keypad
Only if the Monitor has a number keypad, you can use this method.
Make sure the Monitor is standby; then operate in Monitor’s keypad as below:
Input “
80#
” first
Then “
Super Password
“
Then “
New Room Code
“
Press “
#
“
again
to confirm program operation.
For example,
To program 1606 to the Monitor, input: “
8 0 # XXXX 1 6 0 6 #
“
To program 0102 to the Monitor, input: “
8 0 # XXXX 0 1 0 2 #
“
XXXX
means Super Password, please refer to your dealer.
In the procedure, you can press “*” to cancel and re-input.
1
2
3
4
5
6
7
8
9
*
0
#
