13
6. Access Control by Unlock Code
This part explains how to configure the access control by means of keypad, and management of Unlock Code.
6.1.
How to use code unlock function
There are two unlock mode: Common Unlock Mode, Private Unlock Mode, operation is shown as below.
When the Door Station
is standby, Press “#”
Common Mode:
input Unlock Code directly;
Private Mode:
first Input Room Code,
then private unlock code;
If verified correctly,
door open
-
Common Unlock Mode
All users share same Unlock Codes, simple and convenient, and this mode is by default.
There are 2 common unlock codes in 4-digit, both codes are valid, and each can be changed indecently.
Furthermore, 8-digits code mode can be used by joint Unlock Code 1 and Unlock Code 2 together, which
controlled by “Code Nbrs” parameter, see
Chapter 6.4
for reference. If 8-digits code mode is configured, only
one Unlock Code can be used.
-
Private Unlock Mode
In this mode, each user owns his/her Unlock Code, and Room Code is asked before inputting Unlock Code.
Please note only 4-digits code can be used.
In Private Unlock Mode, if not modified, the default code is Unlock Code 1.
User can change Unlock Code by himself/herself, follow these steps:
-
When the Door Station is standby, press “#”, then input Room Code.
-
When password is asked, press “#” again, this is critical for private Unlock Code modification.
-
Input previous Unlock Code correctly.
-
Input new Unlock Code in 4-digits, and re-input once more to ensure confirm.
-
Press “#”, new Unlock Code will be stored, and the Door Station returns to standby state.
Note: during the operation, press “*” to cancel; if no key was pressed in 10s, operation will be aborted.
