Standard Features
Forced Convection Cooling
All Xtant “X” Series amplifiers employ forced convection cooling for thermal man
+
agement
,
An on
+
board thermal sensing circuit regulates fan speed to maintain
optimum operating temperature
,
Please see “Dual Fan Circuit” on page
#
for
additional cooling options
,
Fully Regulated PWM Power Supply
All Xtant “X” Series amplifiers feature a fully regulated
*
Pulse Width Modulated
power supply
,
This supply technology provides high efficiency and consistent out
+
put performance even when battery voltage is less than optimum
,
Crossover
A
$!
/
!"
dB per octave “Butterworth” filter network is standard on the x
$(($
amplifier
,
Both Low Pass and High Pass frequency selection is via a
$!
pin
Frequency Module (SIP)
,
The amplifier is shipped with
&(
Hz SIPs installed
*
$!
other frequencies are available from your Xtant Dealer
,
The crossover’s Low
Pass function is dedicated to the x
$(($
while the High Pass or Bypass functions
are available at the RCA line outputs
,
Balanced / Floating Input
When enabled
*
this circuitry helps to eliminate “system noise” associated with
“ground loops”
,
When combined with the input sensitivity adjustment
*
it allows
the x
$(($
to accept up to
$#
V of input signal
,
Modular Expansion Port
All X series amplifiers are supplied with a modular port(s) used for docking any
of Xtant’s signal processing modules
,
Protection Circuitry
Both Thermal
*
Overcurrent and Low Voltage protection are incorporated into
the x
$(($,
In the event of a problem
*
the amplifier will reduce its power to main
+
tain operation
,
In the case of Low Voltage
*
the amplifier will shut off when the
battery voltage falls to
$$
Volts or less
,
Status LEDs
Three LEDs
*
visible through the cover
*
indicate operational status of the X
$(($
amplifier
,
The red LED illuminates when the amplifier is “ON”
*
the yellow LED
indicates that overcurrent protection is employed and the orange LED indicates
that the thermal protection circuit is operational
,
English
Xtant X1001 Specifications
Frequency Response
)
Hz to
)((
Hz
-
/–
'
dB
Number of Channels
$
Watts per Channel @
"Ω
$
x
)((
Watts per Channel @
!Ω
$
x
$(((
Watts per Channel @
$Ω
$
x
$(((
Distortion (THD)
0
!1
Signal to Noise Ratio
2
&(
dB
Damping Factor
2
!((
@
$((
Hz with
"Ω
Load
Input Sensitivity
$((
mV to
.,)
V RMS Unbalanced
$((
mV to
$#
V RMS Balanced
Input to Line Output Gain
(
dB
-
/–
!(
dB
*
Selectable in
$(
dB Steps
On
+
Board Crossover
$!
or
!"
dB per Octave “Butterworth”
Line Outputs:
Yes
*
High Pass or Bypass Mode
Module Port(s)
!
– Accessory
Power Supply
Fully Regulated
*
Pulse Width Modulated
Operational Voltage
$$
to
$)
Volts
Size (L x W x H)
!(
$$
⁄
$%
” x
$(
)
⁄
$%
” x
!
'
⁄
$%
”
)!)
mm x
!%$
mm x
))
mm
Warranty
Limited
"
Year Parts and Labor
Fusing
Requires
$!(
amp
English
6
7
