6.0 INSTALLATION
Before you begin
1. Determine where you will install your hot water dispenser. The faucet can be mounted in an
existing hole in the sink, or drill a 35mm hole in your sink.
2.
Stainless Steel:
You need a 35mm knockout punch available at most hardware stores or drill
a hole with an expandable drill.
3.
Porcelain:
Proper tools are required to drill through a porcelain or cast iron sink. If you are
not familiar with this process you should consider having this done by a professional plumber.
Do not attempt to drill without these special tools as you may severely damage your sink.
BE SURE TO CONFIRM YOUR FAUCET'S COMPATIBILITY WITH THIS APPLIANCE. FAUCET
MUST BE "OPEN VENT STYLE".
STEP 1 - Mounting Tank
Position tank vertically beneath faucet so flexible tube from the faucet reaches the centre faucet
supply tube on the tank.
Be sure dial is in OFF position during installation
NOTE: The tank must be positioned so the hose to the faucet does not twist
or kink
STEP 2 - Faucet Installation
Follow the installation instruction of the faucet manual.
STEP 3 - Connect Faucet to Tank
1. Connect 1/4" faucet copper line to the rear tube at the top corner of the tank with the quick-
connect fitting supplied with the appliance. Push line straight into quick-connect fitting as far
as possible for both connections.
2. Connect silicone tube to the centre outlet tube on top of tank.
3. Use cable ties to fix the connection tightly. It will create a secure connection when properly
installed.
Be sure the hose is not twisted or kinked. Hose may be shortened if necessary.
NOTE: DO NOT lengthen the hot water hose - dispenser performance will be impaired and
warranty will be void
.
