High impact molded cabinet
This package should
contain:
1.
One dispenser --
pump, electronic
timer/control and
motor in high impact
molded cabinet.
2.
Supply tube (20 ft.)
3.
Drum tube and
holding tubes.
4.
Injection fitting.
5.
Mounting hardware.
6.
Cable ties (25).
7.
Tubing barbs (2).
8.
Battery holder (Models
1080 & 1085 only).
9.
AC adaptor (Models
1070 & 1075 only).
10. Instruction sheet.
Timer
Peristaltic pump
AutoDoseTM Programmable Dispensers From Lyn Distributing
Models 1060, 1065, 1070, 1075, 1080 & 1085: Operation & Maintenance
AutoDose
TM
programmable dispensers are battery operated peristaltic pumping systems (convertible to AC power) which
run automatically at preset times as programmed on an electronic timer/control mechanism. Models vary as to the
pump's power source and the pump tubing material (see page 7 for specifications).
observe safety and handling instructions of the chemical manufacturers.
direct discharge away from you or other persons or into approved containers.
dispense cleaners and chemicals in accordance with manufacturer's instructions. Exercise
CAUTION when maintaining your equipment.
equipment clean for proper operation.
protective clothing and eyewear when working in the vicinity of all chemicals, filling or emptying
equipment or changing tubes.
re-assemble equipment according to instruction procedures. Be sure all components are firmly
screwed or latched into position. Assure that hoses and electrical wire are properly placed and
not kinked or pinched.
ALWAYS
ALWAYS
ALWAYS
KEEP
WEAR
ALWAYS
Please use this equipment carefully and observe all warnings and cautions.
******************************************************************* NOTE ***********************************************************
THANK YOU FOR YOUR INTEREST IN OUR PRODUCTS
System installation ............................................................................................................................................. Pages 2-3
Installing the power supply ................................................................................................................................. Pages 2-3
Determining the proper dosage for application ......................................................................................................... Page 3
Programming the timer ....................................................................................................................................... Pages 3-4
Changing the pump tubing ....................................................................................................................................... Page 5
Troubleshooting ....................................................................................................................................................... Page 5
System parts diagram and list ................................................................................................................................. Page 6
System specifications ............................................................................................................................................. Page 7
Template for wall mounting system ......................................................................................................................... Page 8
TABLE OF CONTENTS
Page 1
