Mobile Dispensing Tank 55lTr wiTh
aDblue puMp - blue
Model no:
DT55bCoMbo1
Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safeTy
warning!
ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
equipment.
9
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
9
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. non authorised parts will invalidate the warranty.
9
ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
dispose of waste liquids in accordance with local authority regulations.
8
Do noT
dismantle, tamper with or adapt the pump for any purpose other than for which it is designed.
8
Do noT
use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
Do noT
use the pump as a handle to move the fluid drum.
9
Keep the pump clean and store in a safe, dry, childproof location.
warning!
Do noT
allow uncontrolled discharge of fluids thus polluting the environment.
2. inTroDuCTion
Manufactured from hard wearing and durable polyethylene. 55ltr Capacity suitable for the distribution of diesel, oil, AdBlue®, Water and
Antifreeze. Available in three configurations and colours, Model No. DT55RCOMBO1 (Red) is supplied with Model No. TP55 Oil Rotary Pump,
DT55GCOMBO1 (Grey) is supplied with Model No. TP96 12V Diesel Pump Kit and DT55BCOMBO1 (Blue) is supplied with Model No. TP6607
AdBlue® Lever Pump. Units are fitted with two roller wheels, hose holder and vent caps. Each tank features a 2”BSP thread and four point
screw fittings enabling other pumps to be fitted as required.
3. asseMbly
3.1.
Extend the suction tube so it reaches the bottom of the tank. Pull it out and screw
it into place on the bottom of the pump (fig.3).
3.2.
Turn the locking ring to the right until all the thread is exposed. Turn the adapter to
the right until it is finger tight (fig.2).
3.3.
Place the pump assembly onto either the left or right hand side ports (fig.1). Start
turning the pump assembly to the right. The adapter ring can be screwed down on
its own if the pump body fowls the handles (fig.2).
3.4.
Attach the hose to the pump by pushing it onto the spout and securing it with a
hose clip (fig.1).
3.5.
Attach the pump
nozzle to the other end of the hose in the same way (fig.4 and 5).
Pump
Body
Locking
Ring
Adapter
fig.3
fig.2
d
T55BCOMBO1 Issue 1 08/01/19
Original Language Version
© Jack Sealey Limited
Refer to
instructions
fig.1
Wear eye
protection
Wear protective
gloves
