Xray T4, Instruction Manual, Page: 19 / 36

19
901302
SB M3x2.5
305392
P 2x10
902205
SH M2x5
940510
BB 5x10x4
980210
P 2x10
REAR TOE-IN
TRACK-WIDTH
DRIVE SHAFTS
#305323 50MM - STEEL
#305324 52MM - STEEL
#305326 52MM - ALU
#305328 50MM - ALU
#305330 52MM - ECS
#305331 50MM - ECS
0° OUTBOARD TOE-IN UPRIGHTS
BEARING OIL
(HUDY #106230)
Use alu 50mm Drive Shaft in rear
Use alu 50mm Drive Shaft in rear
OIL
BEARING OIL
(HUDY #106230)
OIL
4x
THREAD
LOCK
GRAPHITE GREASE
(HUDY #106210)
ONLY FOR REAR
DETAIL STEP
TL
TIP
For easy installation of the #305241
plastic caps, use pliers as shown.
DO NOT
OVERTIGHTEN
Longer drive shafts (52mm) make the car easier to drive because
they give more traction and better stability, mainly in chicanes.
However, the car will understeer more than with shorter (50mm)
shafts which give a lot of steering and impart aggression to the car.
Both left & right shafts should ALWAYS be the same length at one
end of the car (front or rear).
52mm shafts are recommended for carpet and large asphalt tracks.
50mm shafts are recommended for small-medium tight asphalt
tracks.
DO NOT use the plastic caps with composite solid
axle included in the kits.
3.5mm plastic caps are for use ONLY with GEAR
diffs, ALU ball diffs, or the XRAY Multi-Diff™.
ECS shafts are available optionally in both 50mm and
52mm lengths. The ECS drive shafts were developed to
decrease front wheel vibration when racing with a solid
front axle, thus providing a much smoother and quieter
ride and increased steering.
ECS DRIVE SHAFTS - OPTIONAL
IMPORTANT!
REAR TRANSMISSION
L=R
ALTERNATIVE
STANDARD REAR SUSPENSION
INITIAL SETTING
T4 OPTIONAL PARTS
ALTERNATIVE
ACTIVE REAR SUSPENSION™
STANDARD
UPRIGHTS
#303351 1° - R - MEDIUM - 2-HOLE
#303352 0° - R/L - MEDIUM - 2-HOLE
#303353 1° - R - HARD - 2-HOLE
#303354 0° - R/L - HARD - 2-HOLE
#303361 1° - L - MEDIUM - 2-HOLE
#303362 0° - R/L - MEDIUM - 1-HOLE
#303363 1° - L - HARD - 2-HOLE
#303364 0° - R/L - HARD - 1-HOLE
#303358 ALU 1° - R/L - 4-HOLE
#303359 ALU 2° - R/L - 4-HOLE
STANDARD
STANDARD
WHEEL HUBS
#305350-K ALU - OFFSET 0 MM
#305351
ALU - OFFSET -0.75 MM
#305352 ALU - 0.75 MM
#305353 ALU - 1.5 MM
STEERING BLOCKS
#302252 MEDIUM
#302253 HARD
#302256 ALU
5. FRONT & REAR TRANSMISSION
2x
Left Steering Block = Right Steering Block
2x
L=R
Left UPRIGHT = Right UPRIGHT
L=R