Xray T1 EVO2, Instruction Manual

Page: 22 / 23

21
1 1..
Mount the receiver and speed
controller on the car using double-sided
tape. For different receiver mounting
possibilities, refer to the Set-Up Book.
2 2..
Mount the #306300 antenna holder
in an available position, depending on
the position of the receiver. Thread a
#309345 (SFH M3x10) screw from
underneath the chassis into the antenna
holder. Slide the receiver's antenna wire
through the #306310 antenna tube,
and then place the wire in the slot on
the side of the antenna mount. Push the
base of the antenna tube firmly into the
hole of the antenna mount, making
sure you don't pinch or cut the receiver's
antenna wire.
Mount the wheels on the axle hex hubs. Fasten them using #309310
(SH M4x8) screws with #309310 (ST 4x12) cone washers. Note the
orientation of the washer in the illustration.
Make sure the wheel screws are very tight, so the wheels do not come
loose during racing.
The XRAY T1 EVO2 is a top competition racecar, and therefore does not
come supplied with tires and inserts; every track and race requires
different tires and inserts.
Use your own tires and inserts to prepare the tires:
1 1.. Install a foam insert into each tire, making sure it is centred.
2 2..
Slide the tire (with insert) onto the wheel.
3 3..
Carefully glue the tires to the wheels with CA glue.
W Wa arrn niin ng g:: FFo ollllo ow w tth hee a ad dh heessiivvee m ma an nu uffa accttu urreerr''ss iin nssttrru uccttiio on nss ffo orr
p prro op peerr u ussee a an nd d ssa affeettyy.. W Weea arr p prro op peerr eeyyee a an nd d h ha an nd d p prro otteeccttiio on n..
309345
SFH M3x10
309310
SH M4x8
309310
ST 4x12
➋
➊
➊
➋
DETAIL
GLUE
CA
ACCESSORY INSTALLATION
NOT INCLUDED