Xray T1 EVO2, Instruction Manual

Page: 14 / 23

13
302580
or
302582
302551 303450
302630
309010
309414
302501
302660 302610
302501
302650
302501
The servo saver is partially preassembled from the factory and requires only a
few steps to finish.
If you need to assemble the parts yourself, perform the following steps:
1 1.. Place the servo saver spring on the steering post.
2 2..
Place the lower servo saver arm on the steering post.
3 3..
Place the upper servo saver arm on the steering post on top of the lower
arm. Note that the upper and lower arms should interlock at a 90-degree
angle. Check the illustration for proper orientation.
4 4..
Press the servo saver arm down and secure the servo saver with a #309414
(C 4) clip. The clip snaps into a groove on the steering post.
1 1..
Thread a #30 2650 ball end into the lower servo saver. Be sure that the
ball is on top.
2 2..
Thread two #30 2650 ball ends into the upper servo saver arm into the
outside positions as shown. The two balls should be on the bottom.
30 2501 DUAL-ACKERMAN CENTRAL SERVO SAVER (SET)
30 2551 SERVO SAVER PLASTIC COVER - EXCENTRIC (2)
30 2580 NYLON SERVO HORN - KO, JR, AIRTRONICS, MULTIPLEX
30 2582 NYLON SERVO HORN - FUTABA, ROBE
30 2600 ADJ. STEERING ROD L/R 40 MM - SPRING STEEL + BALL JOINT (2+4)
30 2610 ADJ. STEERING ROD L/R 40 MM - SPRING STEEL (2)
30 2630 ADJ. STEERING ROD L/R 20 MM - SPRING STEEL (2)
30 2650 5 MM BALL END, WITH THREAD (6)
30 2660 BALL JOINT 5 MM (6)
30 3450 NYLON BALL JOINT 5 MM - SHORT (4+2)
30 9010 BALL-BEARING MR74ZZ 4x7x2.5 (2)
30 9414 E-CLIP 4 (10)
301180 FLEXIBLE TOP DECK - GRAPHITE - SET
6. SERVO SAVER
➊
➋
➌
➍
➊
➋
FACTORY PREASSEMBLED
309414
C 4
BAG
06
302501