https://www.XPOtool.com
Item 50919–50921
Page 4
The Tool Experts
08 2022-1
Mounting
•
To avoid long suction lines and the resulting power losses the pump should be installed at the
level of the water table or below the water level.
•
It is possible to assemble the pump to the ground. Please use the provided holes in the base
plate to install the pump on a flat surface.
•
The pumps shall be placed in a well ventilated, dry, and flood-proof place.
Placing the hoses
•
The suction hose must be low pressure resistant. Please install it at least 30
cm below the water
level. This is necessary to avoid vortex formation and through this caused air inlet in the system.
•
The pipe connections must be 100
% airtight. Pipe bends and a wavy placing of the hoses must
be avoided if possible. The sucking line should have a minimum descent of 2
% on its complete
length so that no air can remain in the system.
•
The pressure hose should have a diameter at least as large as the diameter of the pressure
joint.
•
The hoses may not lay on the pump. Make sure that all connections are tight so that the pump
does not come in contact with moisture. The pump could be damaged through water!
Start-up
•
Fill the pump with water to make sure that the pump body, filter basket, pipes and other con-
nectors are not leaking. Tighten or loose the screws with hands, or tolls if necessary.
•
Open any existing valves in pressure and suction lines and check that all hoses are connected.
•
Please fill the suction pipe and the pump body completely with water.
•
Plug in the pump and check that the water pump circulates.
•
If the pump is used above the water level of the pool, you must use a foot valve at the suction
hose to avoid that the water runs back in the pool when you do not use the pump.
•
Switch of the pump, when the engine does not start or not water is promoted. In this case check
if something is blocking the water flow.
•
Do not run the pump without water in the pump body. This would damage the mechanical seal
and in this case the pump would leaking.
•
Please do not work on the pump while the pump is running!
•
If you have any problems which are not mentioned in the manual or which you could not explain
please contact an expert.
Maintenance
Our electric pumps require no special maintenance. Please clean regularly the dirt container. During the
cold season, and at longer shut-down of the pump the pump body should be emptied. Please clean the
pump thoroughly with clean tap water to remove all residues of chlorine and other pool stuff. If you do
not clean the pump thoroughly this could damage the seal and causes leaks when you use the pump
again.
