ENG
18
Engl
ish
Initial Installation
On the left side of the screen there is a list of satellites for which the DVB Receiver is pre pro-
grammed. Settings of the chosen satellite is displayed on the right side.
Process:
Select the first satellite to be set up with CH+/CH
Press the OK button. The chosen satellite is marked with a hook, confirming this satellite will
be considered in the coming channel scan.
Press the button
VOL+
to access to right side.
Select the option with
CH+/-
and change the parameter with
VOL+/-
Press
Menu
after defining all parameters for this satellite to get back to the left side.
If your satellite system can receive signals from a number of satellites, select a further satellite
with
CH+/-.
Press OK and define the parameter on the right side.
Repeat this procedure for all satellites available for your receiver.
Notes:
After a correct setting, an approximate value of the signal quality will be shown on the lower
part of the menu.
If a satellite is missing on the list, press the
RED
button. A dialogue winter appears, input the
value for longitude, East/West and frequency, and choose “Blind Scan” in the coming channel
scan. If you add a satellite to the list, there will be no display of the signal quality for this satel-
lite, in spite of correct setting. Signal quality could only be displayed for satellites with pre
installed transponder lists.
Press
GOTO
to display the Transponder of the chosen satellite. Add new transponder with
the
RED
button and mark the transponder for channel scan with
OK
.
Dish Setup-Procedure
